3. Perform the following steps:
a) Disconnect the antenna cables from WLAN card. Un-route the antenna cables from the WLAN
card .
b) Remove the screw that secures the bracket over the display cable and remove the bracket .
c) Disconnect the display cable from the system board.
4. Perform the following steps:
a) Disconnect the touch panel, network connector, and display cables:
b) Remove the screws that secure the display hinges to the palmrest assembly.
c) Lift the palmrest assembly away from the display assembly.
CAUTION: Lift the palmrest assembly slowly to avoid damaging the display assembly.
29
To Next Page
Loading...
