About this task
The following image indicates the location of the display cable and provides a visual representation of the installation procedure.
Steps
1. Connect the display cable from the connector on the camera module.
2. Connect the display cable from the connector on the display panel.
3. Connect the display cable from the connector on the system board.
Next steps
1. Install the display panel.
2. Install the display bezel.
3. Install the display assembly.
4. Install the I/O board cable.
5. Install the WWAN card for 4G LTE enabled systems. .
6. Install the WLAN card.
7. Install the base cover.
8. Exit the service mode
9. Install the SIM card tray for 4G LTE enabled systems.
10. Install the microSD-card.
11. Follow the procedure in after working inside your computer.
94
Removing and installing components
To Next Page
Loading...
