4. Route the WWAN and WLAN card cable through the retention clips on the frame.
5. Route the Speaker through the retention clips and connect it to the system board.
Next steps
1. Install the WWAN card.
2. Install the WLAN card.
3. Install the HDD.
4. Install the solid state drive.
5. Install the battery.
6. Install the base cover.
7. Follow the procedure in After working inside your computer.
Touchpad buttons
Touchpad buttons
Removing the touchpad buttons
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the solid state drive.
5. Remove the HDD.
6. Remove the WLAN card.
7. Remove the WWAN card.
8. Remove the inner frame.
About this task
The figure indicates the location of the touchpad buttons and provides a visual representation of the removal procedure.
58
Disassembly and reassembly
To Next Page
Loading...
