NOTE: The keyboard has multiple snap points on the lattice side which must be pushed down firmly after the
keyboard is replaced.
4. Install the eleven (M2x2) screws to secure the keyboard to the keyboard bracket.
Next steps
1. Install the keyboard.
2. Install the system board.
NOTE: System board can be removed with heatsink attached.
3. Install the memory module.
4. Install the inner frame.
5. Install the WWAN card.
6. Install the WLAN card.
7. Install the HDD.
8. Install the solid state drive.
9. Install the battery.
10. Install the base cover.
11. Follow the procedure in After working inside your computer.
Power button
Removing the power button with fingerprint reader
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the solid state drive.
5. Remove the HDD.
6. Remove the WLAN card.
7. Remove the WWAN card.
8. Remove the inner frame.
9. Remove the memory module.
10. Remove the system board.
NOTE: The system board can be removed along with the heat sink.
About this task
The figure indicates the location of the power button with fingerprint reader and provides a visual representation of the removal
procedure.
Disassembly and reassembly
97
To Next Page
Loading...
