4. Connect the keyboard, keyboard backlit cables on to the connector on the palmrest.
Next steps
1. Install the system board.
NOTE: System board can be removed with heatsink attached.
2. Install the memory module
3. Install the inner frame.
4. Install the WWAN card.
5. Install the WLAN card.
6. Install the HDD.
7. Install the solid state drive.
8. Install the battery.
9. Install the base cover.
10. Follow the procedure in After working inside your computer.
Keyboard bracket
Removing the keyboard bracket
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the solid-state drive.
5. Remove the HDD.
6. Remove the WLAN card.
7. Remove the WWAN card.
8. Remove the inner frame.
9. Remove the memory module.
10. Remove the system board
NOTE: System board can be removed with heatsink attached.
.
11. Remove the keyboard.
About this task
The figure indicates the location of the keyboard bracket and provides a visual representation of the removal procedure.
Disassembly and reassembly
93
To Next Page
Loading...
