Table 45. System Setup options—Keyboard menu(continued)
Keyboard
Device Configuration HotKey Access Allows you to control whether you can access device configuration screens
through hotkeys during system startup.
By default, the Device Configuration HotKey Access option is enabled.
NOTE: This setting controls only the Intel RAID (CTRL+I), MEBX (CTRL+P),
and LSI RAID (CTRL+C) Option ROMs. Other preboot Option ROMs, which
support entry using a key sequence, are not affected by this setting.
NOTE: To view this option, enable Advanced Setup mode as described in
View Advanced Setup options.
Table 46. System Setup options—Pre-boot Behavior menu
Pre-boot Behavior
Adapter Warnings
Enable Dock Warning Messages Enables the warning messages during boot when the adapters with less power
capacity are detected.
By default, the Enable Dock Warning Messages option is enabled.
NOTE: To view this option, enable Advanced Setup mode as described in
View Advanced Setup options.
Warnings and Errors Enables or disables the action to be taken when a warning or error is
encountered.
By default, the Prompt on Warnings and Errors option is selected. Stop,
prompt, and wait for user input when warnings or errors are detected.
NOTE: Errors deemed critical to the operation of the computer hardware
stop the functioning of the computer.
NOTE: To view this option, enable Advanced Setup mode as described in
View Advanced Setup options.
USB-C Warnings
Enable Dock Warning Messages Enables the warning messages during boot when the USB-C adapters with less
power capacity are detected.
By default, the Enable Dock Warning Messages option is enabled.
NOTE: To view this option, enable Advanced Setup mode as described in
View Advanced Setup options.
Fastboot Configure the speed of the UEFI boot process.
By default, the Thorough option is selected. Performs complete hardware and
configuration initialization during boot.
NOTE: To view this option, enable Advanced Setup mode as described in
View Advanced Setup options.
Extend BIOS POST Time Sets the BIOS POST (Power-On Self-Test) load time.
By default, the 0 seconds option is selected.
NOTE: To view this option, enable Advanced Setup mode as described in
View Advanced Setup options.
MAC Address Pass-Through Replaces the external NIC MAC address (in a supported dock or dongle) with the
selected MAC address from the computer.
By default, the System Unique MAC Address option is selected.
Mouse/Touchpad Defines how the computer handles mouse and touchpad input.
118 BIOS Setup
To Next Page
Loading...
