4. Install the base cover.
5. Follow the procedures in After Working Inside Your Computer.
Removing the WWAN Card
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the base cover.
3. Perform the following steps to remove the WWAN card:
a. Disconnect the WWAN cables from their connectors on the WWAN card [1].
b. Remove the screw that secures the WWAN card to the computer [2].
4. Remove the WWAN card from the computer.
Installing the WWAN Card
1. Place the WWAN card into its slot on the computer.
2. Tighten the screw to secure the WWAN card to the computer.
3. Connect the WWAN cables to their connectors on the WWAN Card.
25
To Next Page
Loading...
