Dell Latitude E5550 - Installing the Battery; Removing the Hard-Drive Assembly

4. Perform the following steps:
a. Remove the screw that secures the battery to the computer [1].
b. Lift and push to remove the battery from the computer [2] [3].
Installing the Battery
1. Insert the battery into its place on the computer.
2. Route the battery cable through its routing channel.
3. Tighten the screw to secure the battery to the computer.
4. Connect the battery cable to its connector on the system board.
5. Install the base cover.
6. Follow the procedures in After Working Inside Your Computer.
Removing the Hard-Drive Assembly
1. Follow the procedure in Before Working Inside Your Computer.
2. Remove the:
9