Dell Latitude E5550 - Installing the Display Panel; Removing the Display Hinges

Installing the Display Panel
1. Connect the eDP cable to its connector and fix the adhesive tape.
2. Place the display panel to align with the screw holders on the display assembly.
3. Tighten the screws to secure the display panel to the display assembly.
4. Install the:
a. display bezel
b. battery
c. base cover
5. Follow the procedures in After Working Inside Your Computer.
Removing the Display Hinges
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the:
a. base cover
b. battery
c. memory
d. hard-drive assembly
e. keyboard trim
f. keyboard
g. palmrest
h. display-hinge brackets
i. display assembly
j. display bezel
3. Perform the following steps to remove the display hinges from the display assembly:
a. Remove the screws that secure the display hinges at both sides of the display assembly [1].
b. Remove the display hinges from the display assembly [2].
32