Using Your Projector 29
Using the On-Screen Display
• The projector has a multi-language On-Screen Display (OSD) Menu that can be
displayed with or without an input source.
• Press the Menu button on the control panel or the remote control to enter the
Main Menu.
• To select an option, press the or buttons on your projector’s control panel
or remote control.
• Use the or buttons on the control panel or remote control to adjust the
settings.
• To exit the OSD, press the
Menu
button directly on the control panel or the
remote control.
INPUT SOURCE
The Input Source menu allows you to select your projector's input source.
AUTO SOURCE—If you select and press
to activate, the Auto Source option
will automatically find the next available
input source.
VGA—Press to detect a VGA signal.
DOUSB—Allows you to display the
computer/laptop screen to your
projector via the USB cable.
NOTE: When you connect the projector and computer via the USB cable, a
USB Connected message will pop up and allow you to select input sources as
DoUSB or Storage.
To Next Page
Loading...
