Dell N1548P User Manual

Upgrade Dell EMC Networking N1500 Series Switches
Page 6
Programming controller register
ddr_init2: MemC initialization complete
Validate Shmoo parameters stored in flash ..... OK
Press Ctrl-C to run Shmoo ..... skipped
Restoring Shmoo parameters from flash ..... done
Running simple memory test ..... OK
DeepSleep wakeup: ddr init bypassed 3
DDR Interface Ready
CPLD: addr=0x21, rev=10
Board: L2 48 Port Copper POE+ Switch, X01
DRAM: 1 GiB
NAND: Micron MT29F1G08ABADA, 128 KiB blocks, 2 KiB pages, 16B OOB, 8-bit
NAND: chipsize 128 MiB
In: serial
Out: serial
Err: serial
arm_clk=1000MHz, axi_clk=400MHz, apb_clk=100MHz, arm_periph_clk=500MHz
Unlocking L2 Cache ...Done
l2cc_invalidate - Done, i = 981, invway = 0
Net: Registering eth
Broadcom BCM IPROC Ethernet driver 0.1
Using GMAC0 (0x18022000)
et0: ethHw_chipAttach: Chip ID: 0xdb56; phyaddr: 0x1
ethHw_miiphy_write (addr&f):phyaddr (addr&1f00):bank
ethHw_miiphy_write phyaddr(0x1) bank(0x0) reg(0x0) data(0x2100)
bcmiproc_eth-0
========== relocate address: 0xdff7c000, offset 0xc1f7c000 ==========
boot in 3 s
Creating 1 MTD partitions on "nand0":
0x000000200000-0x000007000000 : "mtd=4"
UBI: attaching mtd1 to ubi0
UBI: physical eraseblock size: 131072 bytes (128 KiB)
UBI: logical eraseblock size: 126976 bytes
UBI: smallest flash I/O unit: 2048
UBI: VID header offset: 2048 (aligned 2048)
UBI: data offset: 4096
1 ecc_errors after reading 2320800:2320a00
UBI: attached mtd1 to ubi0
UBI: MTD device name: "mtd=4"
UBI: MTD device size: 110 MiB
UBI: number of good PEBs: 880
UBI: number of bad PEBs: 0
UBI: max. allowed volumes: 128
UBI: wear-leveling threshold: 4096
UBI: number of internal volumes: 1
UBI: number of user volumes: 1
UBI: available PEBs: 8
UBI: total number of reserved PEBs: 872
UBI: number of PEBs reserved for bad PEB handling: 8
UBI: max/mean erase counter: 37/16
UBIFS: recovery needed
UBIFS: recovery deferred
UBIFS: mounted UBI device 0, volume 0, name "fs"
UBIFS: mounted read-only
UBIFS: file system size: 107802624 bytes (105276 KiB, 102 MiB, 849 LEBs)
UBIFS: journal size: 5459968 bytes (5332 KiB, 5 MiB, 43 LEBs)

Dell N1548P Specifications

General

Model	N1548P
Switching Capacity	176 Gbps
Forwarding Rate	131 Mpps
PoE Power Budget	740 W
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Operating Temperature	0 °C to 45 °C
Device Type	Switch
Enclosure Type	Rack-mountable
Ports	48 x 10/100/1000
Uplink Ports	4 x 10G SFP+
Routing Protocol	OSPF, RIP, VRRP
Remote Management Protocol	SNMP 1, Telnet, SSH, HTTP, HTTPS
Features	Layer 3 switching, IGMP snooping, Link Aggregation Control Protocol (LACP), Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3z, IEEE 802.1D, IEEE 802.1Q, IEEE 802.3ab, IEEE 802.1p, IEEE 802.3af, IEEE 802.3x, IEEE 802.3ad
Dimensions	4.32 cm
Storage Temperature	70 °C
Relative Humidity	10 to 90% (non-condensing)
Jumbo Frame Support	9216 bytes