Figure 22. Installing the N30xx in a Front-Rack Configuration
1
Switch 2 Rail bracket
3 Mounting screw
Installing as a Free-standing Switch
NOTE
: Dell Networking strongly recommends mounting the switch in a rack.
Install the switch on a flat surface if you are not installing it in a rack. The surface must be able to support the weight of the switch and the
switch cables. The switch is supplied with four self-adhesive rubber pads.
1 Attach the self-adhesive rubber pads on each location marked on the bottom of the switch.
2 Set the switch on a flat surface. Make sure that it has proper ventilation by leaving 5 cm (2 inches) on each side and 13 cm (5 inches)
at the back.
Stacking on N30xx Series Switches
This section explains how to stack multiple N30xx series switches.
N30xx Series Installation
35
To Next Page
Loading...
