Steps
1. Align the notch on the solid-state drive with the tab on the solid-state drive connector on the system board.
2. Insert the solid-state drive at a 45-degree angle into the solid-state drive connector.
3. Replace the screw (M2x3.5) that secures the M.2 2280 PCIe solid-state drive to the system board.
Next steps
1. Install the hard-drive assembly.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Hard-drive assembly
NOTE: This section applies to 35 W and 65 W configuration systems.
Removing the hard-drive assembly
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
About this task
The following images indicate the location of the hard-drive assembly and provide a visual representation of the removal
procedure.
Removing and installing components
19
To Next Page
Loading...
