Dell OptiPlex 3010 - Installing the Power Supply

10. Push in on the blue release tab beside the power supply, and slide the power supply towards the front of the
computer.
11. Lift the power supply out of the computer.
Related Links
Installing the Power Supply
Installing The Power Supply
1. Place the power supply in the chassis and slide outward to secure it.
2. Tighten the three screws securing the power supply to the back of the computer.
3. Connect the power cable to the system board.
4. Thread the power cable into the chassis clips.
5. Connect the power cable to the system board.
6. Install the fan shelter.
7. Install the drive cage.
8. Install the front bezel.
9. Install the cover.
27