Installing the hard drive into the hard drive bracket
1. Align and insert the pins on the hard drive bracket with the slots on one side of the hard drive.
2. Flex the other side of the hard drive bracket, and align and insert the pins on the bracket into the hard
drive.
3. Install the:
a. hard drive assembly
b. cover
4. Follow the procedure in After Working Inside Your Computer.
Installing the hard drive assembly
1. Insert the hard drive assembly into the slot on the computer.
2. Slide the hard drive assembly toward the connector until it clicks into place.
3. Install the cover.
4. Follow the procedure in After Working Inside Your Computer.
Removing the VGA board
1. Follow the procedure in Before Working Inside Your Computer.
2. Remove the cover.
3. To remove the VGA board:
a. Disconnect the VGA board cable from the connector on the VGA board [1].
b. Remove the screws that secure the VGA board to the computer [2].
c. Slide the VGA board to disengage the connector from the slot and lift it away from the computer
[3].
10
To Next Page
Loading...
