Dell OptiPlex 3040M Series - Installing the VGA Board; Removing the System Fan

Installing the VGA board
1. Align and insert the VGA connector into the slot on the computer.
2. Tighten the screws to secure the VGA board to the computer.
3. Connect the VGA board cable to the connector on the VGA board.
4. Install the cover.
5. Follow the procedure in After Working Inside Your Computer.
Removing the system fan
1. Follow the procedure in Before Working Inside Your Computer.
2. Remove the cover.
3. To remove the system fan:
a. Press the blue tabs on both sides of the system fan [1].
b. Push the system fan to release it from the computer [2].
c. Turn the system fan over to remove it from the computer [3].
11