Dell OptiPlex 390 - Installing The Power Supply

Installing The Power Supply
1. Place the power supply in the chassis and slide outward to secure it.
2. Use a Phillips screwdriver to tighten the three screws securing the power
supply to the back of the computer.
3. Connect the power cable to the system board.
4. Thread the power cable into the chassis clips.
5. Connect the power cable to the system board.
6. Install the fan shelter .
7. Install the
drive cage .
8. Install the front bezel .
9. Install the cover .
10. Follow the procedures in After Working Inside Your Computer .
43