Installing The Drive Cage
1. Place the drive cage on the edge of the computer to allow access to the
cable connectors on the hard drive.
2. Connect the data cable and power cable to the back of the hard drive.
3. Flip over the drive cage and insert it into the chassis. The drive cage tabs
are secured by the slots in the chassis.
4. Slide the drive-cage handle toward the front of the computer into the
locked position.
5. Connect the data cable and power cable to the back of the optical drive.
6. Install the
front bezel
.
7. Install the
cover
.
8. Follow the procedures in
After Working Inside Your Computer
.
51
To Next Page
Loading...
