Steps
1. Place the hard-drive onto the caddy aligning the posts on the left side with the slots on the hard-drive. Push the tabs from the right
side of the caddy away from the hard-drive until the hard-drive clicks in place.
2. Connect the power cable and hard-drive cable to the connectors on the hard drive.
Next steps
1. Install the front bezel.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Installing the hard-drive bracket
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the hard-drive bracket and provides a visual representation of the installation procedure.
26
Field service information
To Next Page
Loading...
