Dell OptiPlex 7080 Small Form Factor - Removing the M.2 2280 Pcie Solid-State Drive

Steps
1. Align the solid-state drive with the socket on the system board and slide it in.
2. Replace the screw (M2X3) that secures the M.2 PCIe solid-state drive to the system board.
Next steps
1. Install the 2.5 in. hard drive assembly.
2. Install the front bezel.
3. Install the side cover.
4. Follow the procedure in after working inside your computer.
Removing the M.2 2280 PCIe solid-state drive
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5 in. hard drive assembly.
About this task
The following images indicate the location of the solid-state drive and provide a visual representation of the removal procedure.
Field service information
29