4. Install the single (M2x3) screw to secure the WLAN card.
Next steps
1. Install the 2.5 in. hard drive assembly.
2. Install the front bezel.
3. Install the side cover.
4. Follow the procedure in after working inside your computer.
Heat sink
Removing the fan assembly
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
About this task
The following images indicate the location of the fan assembly and provide a visual representation of the removal procedure.
36
Field service information
To Next Page
Loading...
