Steps
1. Disconnect the hard-drive data and power cables from the connectors on the hard drive and push the left tab towards the
hard-drive to free the caddy from the chassis
2. Release the hard-drive caddy from the tabs on the right side and slide the hard-drive caddy out.
NOTE:
The hard-drive's power and data cables can only connected from the bottom side of the caddy. Make a note of
the orientation of the hard drive to avoid errors during installation.
Removing the 2.5-inch hard-drive
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5/3.5-inch hard-drive caddy.
About this task
The following images indicate the location of the hard drive and provide a visual representation of the removal procedure.
NOTE:
The hard-drive caddy can hold both 2.5-inch and 3.5-inch hard drives simultaneously. Turn over the caddy to find
the second set of mounting points for hard-drives.
20 Removing and installing components
To Next Page
Loading...
