Steps
1. Insert the coin-cell battery into its slot on the system board with the positive side (+) label facing up.
2. Press down and snap the coin-cell battery into the slot on the system board.
Next steps
1. Install the graphics card.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Memory modules
Removing the memory modules
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the 2.5/3.5-inch hard-drive caddy.
4. Remove the hard-drive and optical-drive bracket.
NOTE:
CAUTION: To prevent damage to the memory module, hold the memory module by the edges. Do not touch the
components on the memory module.
About this task
The following images indicate the location of the memory modules and provide a visual representation of the removal procedure.
Removing and installing components
43
To Next Page
Loading...
