Steps
1. Place the tabs on the right side of the hard-drive caddy onto the holders on the chassis and push the left side of the caddy
down until it clicks into place.
NOTE: Use the arrows seen on the caddy as guides to identify the tabs on the tray.
2. Connect the hard-drive data and power cables to the connectors on the hard drive.
Next steps
1. Install the front bezel.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Installing the 2.5-inch hard-drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image shows the hard-drive and provides a visual representation of the installation procedure.
22
Removing and installing components
To Next Page
Loading...
