Steps
1. Remove the screw (6-32) that secures the front I/O bracket to the chassis.
2. Lift the front I/O panel away from the chassis.
3. Unroute the SATA cables from the cable routing guide on the metal bracket.
4. Remove the two (6-32) screws from the metal bracket from over the M.2 SSD slot and lift it away from the system.
5. Disconnect the following cables from their connectors on the system board:
● Intrusion switch
● ATX system board power supply cables
● Power button switch
● ATX CPU power supply cable
● SATA data cables
● SATA power cable
● Fan cable
6. Remove the four screws (6-32) and the single standoff screw (M2x4) which secure the system board to the chassis.
7. Free the system board from the back I/O panel by sliding it towards the right and lift the system board out of the chassis.
Installing the system board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the system board and provides a visual representation of the installation procedure.
Removing and installing components
59
To Next Page
Loading...
