Steps
1. Align the notch on the solid-state drive with the tab on the M.2 card slot.
2. Slide the solid-state drive into the M.2 card slot on the system board.
3. Replace the screw (M2x3) that secures the solid-state drive to the system board.
4. Re-route the SATA cables through the cable management tab.
5. Replace the two screws (6x32) to secure the metal bracket to the computer.
Next steps
1. Install the 2.5/3.5-inch hard-drive caddy.
2. Install the front bezel.
3. Install the side cover.
4. Follow the procedure in after working inside your computer.
Removing and installing components
27
To Next Page
Loading...
