Dell OptiPlex GX520 - Installing a PCI Card

Back to Contents Page
Dell™OptiPlex™GX520User'sGuide
PCI and PCI Express Cards and Serial Port Adapters
PCI and PCI Express Cards and Serial Port Adapters

YourDell™computersupportsaserialportadapterandprovidestwolow-profile PCI card slots for PCI cards:

PCI Cards

Installing a PCI Card

1. Follow the procedures in "Before You Begin."

2. Gently push the release tab on the card retention latch.

3. If you are installing a new card, remove the filler bracket to create a card-slot opening. Then continue with step 5.

4. If you are replacing a card that is already installed in the computer, remove the card. If necessary, disconnect any cables connected to the card.

5. Prepare the card for installation.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
NOTE: Your Dell computer uses only PCI slots. ISA cards are not supported.
NOTE: See the documentation that came with the card for information on configuring the card, making internal connections, or customizing it for your
computer.
1
card retention latch
2
release tab
3
card
4
card-edge connector
5
card connector