Dell OptiPlex GX520 - Chassis Intrusion Switch; Removing the Chassis Instrusion Switch

Back to Contents Page
 Chassis Intrusion Switch
Dell™OptiPlex™GX520User'sGuide
Removing the Chassis Instrusion Switch
Replacing the Chassis Intrusion Switch
Resetting the Chassis Intrusion Detector

Removing the Chassis Instrusion Switch

1. Follow the procedures in "Before You Begin."

2. Disconnect the chassis intrusion switch cable from the system board.
Note the routing of the chassis intrusion cable as you remove it from the chassis. Chassis hooks may hold the cable in place inside the chassis.

3. Using a flat blade screwdriver, gently slide the chassis intrusion switch out of its slot, and remove the switch and its attached cable from the computer.

Mini Tower Computer

Desktop Computer
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTE: The chassis intrusion switch is optional and may not ship with your computer.