Dell OptiPlex GX520 - Removing the I;O Panel; Replacing the I;O Panel

Back to Contents Page
Dell™OptiPlex™GX520User'sGuide
I/O Panel
I/O Panel

Removing the I/O Panel



1. Follow the procedures in "Before You Begin."

2. Remove the cable from the I/O panel by pulling on the pull-loop.

3. Remove the screw that secures the I/O panel to the desktop computer.

4. Gently rotate and slide the I/O panel away from the computer.

Replacing the I/O Panel

1. To replace the I/O panel, follow the removal procedures in the reverse order.
Back to Contents Page
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
NOTE: Note the routing of all cables before disconnecting them, so that you can re route them correctly when installing the new I/O panel.
NOTICE: When sliding the I/O panel out of the computer, be extremely careful. Carelessness may result in damage to the cable connectors and the
cable routing clips.
1
securing screw
2
I/O panel
3
I/O cable connector
4
I/O connector pull-loop
NOTE: Use the guides on the I/O panel bracket to help position the I/O panel in place and use the notch on the I/O panel bracket to help seat the card.