<F2> or <Ctrl><Alt><Enter>
starts embedded system setup (during system start-
up only)
automatically starts the computer from the network
environment specified by the remote boot
environment (PXE) rather than from one of the
devices in the system setup Boot Sequence option
(during system start-up only)
displays a boot device menu that allows the user to
enter a device for a single boot (during system start-
up only) as well as options to run hard-drive and
system diagnostics
green light — Blinking green indicates a sleep mode;
solid green indicates a power-on state.
amber light — Blinking amber indicates a problem
with an installed device; solid amber indicates an
internal power problem (see "Power Problems").
solid green light indicates network connection
Link integrity light (on integrated network adapter)
green light for 10-Mb operation; orange light for 100-
Mb operation; yellow light for a 1000-Mb (1-Gb)
operation
Activity light (on integrated network adapter)
four lights on the back panel (see "Diagnostic Lights")
AUX_PWR on the system board
751 BTU/hr
NOTE: Heat dissipation is calculated based upon the
power supply wattage rating.
manual selection power supplies — 90 to 135 V at
50/60Hz;180to265Vat50/60Hz
3-V CR2032 lithium coin cell
10°to35°C(50°to95°F)
–40°to65°C(–40°to149°F)
20% to 80% (noncondensing)
0.25 G at 3 to 200 Hz at 0.5 octave/min
0.5 G at 3 to 200 Hz at 1 octave/min
bottom half-sine pulse with a change in velocity of
50.8 cm/sec (20 inches/sec)
27-G faired square wave with a velocity change of
508 cm/sec (200 inches/sec)
–15.2 to 3048 m (–50 to 10,000 ft)
–15.2 to 10,668 m (–50 to 35,000 ft)