Dell OptiPlex XE - Removing the Memory; Replacing the Memory

Back to Contents Page
Memory
Dell™OptiPlex™XEServiceManual—Desktop
Removing the Memory
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the optical drive.
3. Press down on the memory retention clips to release the memory module.
4. Lift the memory module out of its connector and remove it from the computer.
Replacing the Memory
To replace the memory, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe®Flash®Player from Adobe.com in order to view the illustrations below.