Dell P104F002 - Installing the M.2 2230 Solid-State Drive Holder

Steps
Pry and remove the M.2 2230 solid-state drive holder from the screw hole on the system board.
Installing the M.2 2230 solid-state drive holder
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the M.2 2230 solid-state drive holder and provides a visual representation of the
installation procedure.
Steps
Align and insert the solid-state drive holder on the system board to accommodate the M.2 2230 solid-state drive.
Removing and installing components
33