Steps
Place the palm-rest assembly on a flat surface.
Next steps
1. Install the smart card reader, if applicable.
2. Install the display assembly.
3. Install the system board.
4. Install the assembly inner frame.
5. Install the battery.
6. Install the heat sink.
7. Install the M.2 2230 solid-state drive in Slot 2, if applicable.
8. Install the M.2 2230 or M.2 2280 solid-state drive in Slot 1, as applicable.
9. Install the memory modules.
10. Install the WLAN card.
11. Install the 4G WWAN card or 5G WWAN card, as applicable.
12. Install the base cover.
13. Install the SIM card.
14. Follow the procedure in After working inside your computer.
Removing and installing Field Replaceable Units (FRUs)
127
To Next Page
Loading...
