Dell P2422HA - Page 52

52 │ Operating your monitor
When the monitor goes into Standby mode, the following message appears:
Going into Standby mode...
Activate the computer and wake up the monitor to gain access to the OSD.
If VGA, HDMI, or DisplayPort cable is not connected, a floating message box as
shown below appears. The monitor will enter Standby Mode after 4 minutes if left
at this state.
No VGA Cable
The display will go into Standby mode in 4 minutes.
www.dell.com/P2422HA
or
No HDMI Cable
The display will go into Standby mode in 4 minutes.
www.dell.com/P2422HA
or
No DP Cable
The display will go into Standby mode in 4 minutes.
www.dell.com/P2422HA