26 | Setting up the monitor
Setting up the monitor
Connecting the stand
NOTE: The stand riser and stand base are detached when the monitor is
shipped from the factory.
NOTE: The following instructions are applicable only for the stand that
was shipped with your monitor. If you are connecting a stand that you
purchased from any other source, follow the set up instructions that were
included with the stand.
CAUTION: Place monitor of a flat, clean, and soft surface to avoid
scratching the display panel.
To attach the monitor stand:
1. Align and place the stand riser on the stand base.
2. Open the screw handle at the bottom of the stand base and turn it clockwise
to secure the stand assembly.
3. Close the screw handle.
1
2
3
To Next Page
Loading...
