Dell P3221D - OSD Warning Messages

54 | Operating the monitor
OSD warning messages
When the monitor does not support a particular resolution mode, you can see the
following message:
The current input timing is not supported by the monitor display.
Please change your input timing to 2560x1440, 60Hz or any other
monitor listed timing as per the monitor specications.
This means that the monitor cannot synchronize with the signal that it is receiving
from the computer. See Resolution specifications for the Horizontal and Vertical
frequency ranges addressable by this monitor. Recommended mode is 2560 x 1440.
You can see the following message before the DDC/CI function is disabled:
The function of adjusting display setting using PC
application will be disabled.
Do you wish to disable DDC/CI function?
Yes
No
When the monitor enters the Standby mode, the following message will appear:
Going into Standby Mode
Activate the computer and wake up the monitor to gain access to the OSD.
If you press any button other than the power button, the following messages will
appear depending on the selected input:
No USB-C signal from your device.
Press any key on the keyboard to wake it up.
If there is no display, press the monitor joystick to select
correct input sources.