Dell P72F - Removing the Computer Base; Prerequisites; Procedure

Removing the computer base
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Prerequisites
1 Remove the base cover.
2 Remove the battery.
3 Remove the rear cover.
4 Remove the wireless card.
Procedure
1 Using pull tab, disconnect the camera cable from the system board.
2 Peel the camera cable o the computer base.
3 Remove the antenna cables from the routing guides on the computer base.
4 Remove the screw (M2x3) that secures the display-cable bracket to the
computer base.
5 Lift the display-cable bracket o the computer base.
6 Using the pull tab, disconnect the display cable from the system board.
44