Replacing the status-light board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Align the screw holes on the status-light board with the screw holes on the
computer base.
2 Replace the screw (M2x3) that secures the status-light board to the computer
base.
3 Slide the status-light board cable into the connector on the status-light board
and close the latch to secure the cable.
Post-requisites
1 Follow the procedure from step 5 to step 21 in Replacing the computer base.
2 Replace the rear cover.
3 Replace the battery.
4 Replace the base cover.
55
To Next Page
Loading...
