Steps
1. Align the notch on the solid-state drive module with the tab on the solid-state drive slot.
2. Slide the solid-state drive module firmly into the solid-state drive slot at an angle.
3. Replace the screw (M2x4) that secures the solid-state drive module to the system board.
Next steps
1. Connect the battery cable.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Speakers
Removing the speakers
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The figure indicates the location of the speakers and provides a visual representation of the removal procedure.
28
Removing and installing components
To Next Page
Loading...
