Introduction 13
• Do not locate the switch where there may be data or electrical cabling located directly
behind the unit.
• The power cable must reach an outlet.
2
Use the supplied screws to attach a mounting bracket to each side of the switch (see
Figure 1-8).
Figure 1-8. Brackets for Wall Installation
3
Place the switch against the wall and mark the wall through the holes of the brackets.
4
Drill holes in the wall for the brackets and install the appropriate mounting hardware (not
supplied).
5
Place the switch against the wall so that the bracket holes align with the holes in the wall.
6
Insert and tighten the screws through each of the mounting brackets.
Technical Information
Table 1-2. Specifications
Network Protocol and Standards Compatibility
IEEE 802.3 CSMA/CD
IEEE 802.3 10Base-T
IEEE 802.3u 100Base-TX
IEEE 802.3z/ab 1000Base-T
IEEE 802.3x Flow Control
IEEE 802.1p Priority
To Next Page
Loading...
