Dell PowerConnect 5224 - Page 11

CLI Commands
The following table summarizes the equivalent CLI commands for items in the Switch/General/Asset page.
Example
Console(config)#hostname Server Chassis 35
Console(config)#snmp-server contact Paul
Console(config)#snmp-server location WC-19
Console(config)#exit
Console#show system
System description: PowerConnect 5224
System OID string: 1.3.6.1.4.1.674.10895.4
System information
SystemUptime:0days,0hours,14minutes,and17.93seconds
SystemName:ServerChassis35
SystemLocation:WC-19
SystemContact:Paul
MACaddress:00-00-e8-00-00-02
Webserver:enable
Webserverport:80
POSTresult:
--- Performing Power-On Self Tests (POST) ---
UART Loopback Test ..................... PASS
Timer Test ............................. PASS
CACHE Test.............................. PASS
DRAM Test .............................. PASS
I2C Initialization ..................... PASS
Runtime Image Check .................... PASS
PCI Device Check ....................... PASS
Switch Driver Initialization ........... PASS
Command
Usage
show system
Displays system information
hostname name
Specifies or modifies the system name for this device
snmp-server contact string
Sets the system contact (sysContact) string
snmp-server location text
Sets the system location string