Dell POWERCONNECT 5524 - GUI Problem in VLAN Pages; Voice VLAN and Lags; Vulnerabilities and Dos Attacks Reported on SSH Service; Powerconnect 55 Xxp Having Problem Providing Power When Using Shortel IP230 G Phones (PSE;PTR Issue - 213880)

PowerConnect 5500 Series Release Notes
System Firmware Version 4.1.0.16 Subject to Change Without Notice Page 7
GUI problem in VLAN pages
"apply" and "cancel" button disappear from VLAN
port setting edit page if interface includes
command to remove certain VLANs
Issue resolved
Voice VLAN and LAGs
Device crashes when Adding Voice VLAN
enabled ports to a LAG
Issue resolved
vulnerabilities and DoS attacks
reported on SSH service
Reports of SSH vulnerabilities on device
Upgrade to OpenSSH
version 5.9
The following is a list of issues resolved between 4.1.0.05 and 4.1.0.08 firmware release.
Description
User Impact
Resolution
PowerConnect 55xxP having
problem providing power when using
Shortel IP230G phones (PSE/PTR
issue - 213880)
The Shortel IP230G phones don’t work.
Issue was related to phone
requesting/consuming power beyond the limit
of the class it was advertising
Additional global option was
added to allow switch to
provide power up to the
max limit of 15.4W
regardless of device POE
class.
PC55xx - speed not listed for 10Gb
ports in Web GUI unless page was
refreshed.
In Web GUI the current speed of the 10Gb
ports is not presented
Issue resolved
PC55XX MIB OIDs for optical
transceivers conversion from bBm to
mWatt is mistaken
Wrong mWatt values are displayed in CLI and
Web GUI
Issue resolved
Routed traffic in the device is using
the port MAC as the SMAC instead
of the device MAC
In some rare cases this behavior would affect
the ability of end stations to use the switch
interface as a default gateway.
Issue resolved. Device
base MAC is always used
as SMAC when routing
traffic
Web GUI displays tagged VLANs as
Inactive configuration
Wrong configuration is being shown to the
user. CLI displays accurate information.
Issue resolved