94 PowerConnect B-Series FCX Web Management Interface User Guide
53-1002268-01
Configuring a TACACS/TACACS+ server
4
FIGURE 75 Add a Log Server
The System Log Server display contains the following information.
Configuring a trap
Select Configure > System > Management > Trap to configure a trap. Click Apply to save the
configuration or click Reset to undo changes.
Server IP Address Displays the IP address of IPv4 or IPv6.
Server Udp Port This parameter specifies the application port used for the Syslog facility. The default is
514.
Add Allows you to add the server IP Address.
Delete Allows you to delete the changes made.
Reset To undo your changes, click Reset.
Show Log Server Displays the Log Server entries.
Show System Log Clicking this displays the default screen of the system log.
To Next Page
Loading...
Need help?
General