8 Installing the Tower-to-Rack and Rack-to-Tower Kits
www.dell.com | support.dell.com
Figure 1-3. Removing the System Stabilizer Feet
Attaching the Rack-Adapter Plate
1
Remove the system’s right-side cover:
a
Remove the two back-panel screws that secure the right-side cover to the chassis. See
Figure 1-4.
b
Slide the right-side cover toward the back of the system and then lift it away from the
chassis.
system stabilizer feet (4)
securing screws (4)
P2648bk0.book Page 8 Thursday, October 14, 2004 11:18 AM
To Next Page
Loading...
