Installing the Tower-to-Rack and Rack-to-Tower Kits 15
Attaching the System Stabilizer Feet
1
Locate a stabilizer foot, a circular swivel disk, and a Phillips screw from the rack-to-tower kit.
2
Place the circular swivel disk inside the circular cavity on the bottom of the stabilizer foot and
rotate it until it seats completely inside the cavity.
The swivel disk properly seats inside the cavity when the inner-disk tab on the swivel disk
inserts into the swivel slot on the stabilizer foot. See Figure 1-13.
3
Attach the stabilizer feet to the left side of the chassis:
a
Position each stabilizer foot as shown in Figure 1-13.
b
Insert the inner-disk tab on the swivel disk into the slot in the chassis.
c
Secure the stabilizer foot to the chassis with a Phillips screw.
4
Repeat step 1 through step 3 to attach the other three stabilizer feet.
Figure 1-13. Attaching the System Stabilizer Feet
system stabilizer feet (4)
securing
screws (4)
swivel disks (4)
inner-disk tab
swivel slot
P2648bk0.book Page 15 Thursday, October 14, 2004 11:18 AM
To Next Page
Loading...
