Dell PowerEdge 1800 - Front-Panel Indicators and Features

10 Installing the Tower-to-Rack and Rack-to-Tower Kits
www.dell.com | support.dell.com
Attaching the Rack Handles
1 Position one rack handle on the side of the chassis so that the handle’s pull-loop is nearest the
top of the system. See Figure 1-6.
2 Align the three screw holes on the rack handle with the three screw holes on the side of
chassis.
3 Use three of the hex-head Phillips screws that are supplied with your kit to secure the rack
handle to the chassis.
NOTE: To obtain proper alignment of the rack handle, tighten the top screw first, the bottom screw
second, and the middle screw last.
4
Repeat step 1 through step 3 to attach the other rack handle.
Figure 1-6. Installing the Rack Handles
Attaching the Slide-Shoulder Screws
Your kit includes six shoulder screws that enable the system to be attached to rack slides. Attach
three slide-shoulder screws to each side of the chassis. See Figure 1-7.
rack handles (2)
hex-head Phillips
screws (6)
pull-loop
P2648bk0.book Page 10 Thursday, October 14, 2004 11:18 AM