Installing the Tower-to-Rack and Rack-to-Tower Kits 13
Removing the Rack Handles
Remove the three hex-head Phillips screws that secure each rack handle to the chassis. See
Figure 1-10.
Figure 1-10. Removing the Rack Handles
Attaching the Side Cover
1
Remove the rack-adapter plate:
a
Remove the two back-panel screws that secure the rack-adapter plate to the chassis. See
Figure 1-11.
b
Slide the rack-adapter plate toward the back of the system and then lift it away from the
chassis.
rack handles (2)
hex-head Phillips
screws (6)
P2648bk0.book Page 13 Thursday, October 14, 2004 11:18 AM
To Next Page
Loading...
