Dell PowerEdge C6220 - Power and System Board Indicator Codes

31 PowerEdge C6220 Technical Guide
Environmental specifications
Table 19 details the environmental specifications for the PowerEdge C6220. For the most up-to-
date information, see the Dell PowerEdge C6220 Getting Started Guide on
Dell.com/Support/Manuals. For additional information about environmental measurements for
specific system configurations, see Dell.com/environmental_datasheets.
Table 19. Environmental specifications
Temperature
Operating
10°C to 35°C (50°F to 95°F) with a maximum temperature gradation of 10°C per hour. Note:
For altitudes above 2950 feet, the maximum operating temperature is de-rated 1°F/550 ft
Storage
−40°C to 65°C (−40°F to 149°F) with a maximum temperature gradation of 20°C per hour
Relative humidity
Operating
20% to 80% (non-condensing) with a maximum humidity gradation of 10% per hour
Storage
−40°C to 65°C (−40°F to 149°F) with a maximum temperature gradation of 20°C per hour
Maximum vibration
Operating
0.26 Grms at 5Hz to 350Hz for 5 minutes in operational orientations
Storage
1.88 Grms at 10Hz to 500Hz for 15 minutes in all orientations
Maximum shock
Operating
One shock pulse in the positive z-axis (one pulse on each side of the system) of 31G for
2.6 ms in the operational orientation
Storage
Six consecutively executed shock pulses in the positive and negative x, y, and z axes (one
pulse on each side of the system) of 71G for up to 2 ms.
Six consecutively executed shock pulses in the positive and negative x, y, and z axes (one
pulse on each of the system) of 22G faired square wave pulse with velocity change at
200 in/second (508 cm/second)
Altitude
Operating
−15.2 m to 3048 m (−50 ft to 10,000 ft) Note: For altitudes above 2950 feet, the maximum
operating temperature is de-rated 1°F/550 ft
Storage
−15.2 m to 10,668 m (−50 ft to 35,000 ft) Note: For altitudes above 2950 feet, the maximum
operating temperature is de-rated 1°F/550 ft
Airborne contaminant level
Class G1 or lower as defined by ISA-S71.04-1985
Video specifications
The baseboard management controller (BMC) for the PowerEdge C6220 incorporates an integrated
video subsystem that is connected to the 32-bit PCI interface of the ICH10R. The logic is based on
the ATS2050 and supports 2D graphics only. The video device output is available only as a back
video port. The integrated video core shares its video memory with the BMC’s 64 MB DDR2
application space memory. This memory is also used for the KVM buffer. The PowerEdge C6220
system supports the 2D graphics video modes listed in Table 20.