Managing Your Remote Console Switch Using the On-board Web Interface 121
Figure 6-14. Upgrade Switch Firmware Window
4
Click the
Upgrade
button. The
Upgrade
button dims and a progress
message and progress bar appears.
5
When the upgrade is complete, the Remote Console Switch will reboot.
NOTICE: Do not power down the Remote Console Switch while it is upgrading.
You can upgrade firmware for all SIPs of a given type.
To simultaneously upgrade multiple SIPs:
1
Click the
Tools
tab in the on-board web interface. The
Tools
window
appears.
2
Click the
Upgrade SIP Firmware
button. The
Upgrade SIP Firmware
window appears.
3
Click the check box in front of each type (PS/2,USB, USB2, Serial, or Sun)
of SIP you wish to upgrade.
NOTE: A disabled check box indicates that all SIPs of that type are running the
correct firmware, or that no SIP of that type exists in the system.
To Next Page
Loading...
