128 Installing System Components
5
Using a #2 Phillips screwdriver, loosen one of the heat-sink retention
screws. See Figure 3-23.
6
Wait 30 seconds for the heat sink to loosen from the processor.
7
Loosen the other heat-sink retention screws.
8
Gently lift the heat sink off the processor and set the heat sink aside upside
down (thermal grease side facing up).
Figure 3-23. Removing and Installing the Heat Sink
CAUTION: The processor is held in its socket under strong pressure. Be aware
that the release lever can spring up suddenly if not firmly grasped.
9
Position your thumb firmly over the processor socket-release lever and
release the lever from the locked position. Rotate the lever 90 degrees
upward until the processor is released from the socket. See Figure 3-24.
1 heat-sink retention screw (4) 2 heat sink
R415HOM.book Page 128 Friday, September 24, 2010 9:37 AM
To Next Page
Loading...
